"
I would say they are spread out but there are a few near injection site yes and I don't think they was there before
"
Unlikely to be entry marks from the needles then. I doubt its related to MT2 as I've not seen the sides before.
There are many things that can cause spots and are generally short lived.
If you're worried or they get worse, get them checked out by your doctor/dermatologist.
what are you using for alcohol ? rubbing alcohol and the little hand cleaner things are not pure alcohol , knew of one MT user that used rubbing alcohol and had a* reaction like yours , as you do drag a tiny bit if what's on the surface on injecting.
I am currently using bacteriostatic water and it's quite interesting I didn't have the same reaction as with sodium chloride I had zero spots, in fact I didn't nearly have as half freckles either bought from same supplier also tom I will make sure to get it checked out and tell you of the results
I have had these too! They mainly come up on my shoulders. They dissappear when I stop injecting and come back as soon as I've started again. It's no coincidence! They don't bother me too much and are not massively noticeable, so not too bad as sides go...!
"
I am currently using bacteriostatic water and it's quite interesting I didn't have the same reaction as with sodium chloride
"
My guess is that your response comes from bacteria in the injection water and reminiscent of blood poisoning. Add Benzyl Alcohol to Sodium Chloride, as I do.
Reply With Quote