Has TB-500 helped others recover from injuries? Also wondering how many mg's of TB-500 I would need for 3-4 months.
Has TB-500 helped others recover from injuries? Also wondering how many mg's of TB-500 I would need for 3-4 months.
Thanks so much greatly appreciated. Just trying to figure out how many Mgs for 3-6 months is the tricky part. Doctor prescribed me naproxen antiflamitory but that goes straight through the liver. Want to see if a doctor will prescribe it.
I figured out dosage I only have 5 mg's of it which isn't enough.
Last edited by Stasiak; 5th January 2016 at 12:22 PM.
I used 250mcg twice a day. I had shoulder pain and now it's almost gone.
You will need much more if you want to run it for atleast 3 months. Good protocol is 2.5mg a week for 10 weeks then 5 mg every other month for maitenence. Also most people under dose peptides so they don't get the best effects. At this dose you will significantly feel it.
Used bpc 157 on my pec minor tear. Did 1 mg a day for 2 weeks. I would say it works like a charm. I did direct injections into pec tear. You have to inject it directly in injury. You can literally do like 200mcg daily with amazing results. Works better then tb-500 for tendons and ligaments. Stack both together and you will be good to go.
Just found this article LGD-4033 in web shops is authentic – TB-500 is not
Can somebody PM me legit source?
Tried TB 500 for arthritic pain. Did the 2 mg 2 times a week for a month. No more shoulder or lower back pain. BP 157 may have helped also but I did not have a insulin syringe to pin with so sight specific was difficult. Also a side effect was 50% less grey hair.
Same, I swear by tb-500 (you need legit tb500 though), has substantially improved my lower back and left elbow niggling pain from years of heavy lifting has completely gone, amazing stuff.
TB 500 from what I have read is not location specific. I just pinned in the shoulder where everything else gets pinned. BPC 157 I have read is location specific.
Can either TB500 or BPC157 be taken orally?
I'm going to be injecting TB-500 and BPC, but I am not sure exactly what size and length to get for injection. I obviously wanna avoid scar tissue in the injection site, so I am guessing 30 gauge? If I get a needle too thick and make scar tissue, I think that would defeat the entire purpose of trying to heal a muscle.
You can't get scar tissue with under skin injection. And Tb-500, Bpc-157 is just water so no problem.
When injecting tb-500 and bpc157, how far do you go in? Do you inject it just under the skin, or into the muscle?