I load my PWO peps (mod grh 1-29 & ghrp2) about 2 hours prior to use. I put the syringes in a cold pack and take them at the gym immediately after training. I'd like to combine them in one syringe. I am sure I read somewhere in all this huge mass of information that you can combine them in a single syringe. If true, how long can they be in contact? Is 2 hours in a cool state too long for them to be in contact with each other?
I'm not sure on the exact times but I mix all 3 in the same syringe and they work just fine for me and I usually combine them 3 hours prior to usage.
You can also load a little air in between peptides so this won't be a concern.
that's a really good idea Abigail!Originally Posted by Abigail
Is there any concern that there will always be some residual peptide on the needle - and then you're dipping it into yet another peptide, etc? It may sit there for weeks, mixing, etc.
I think the rubber stopper wipes 99.9% of the peptide off the needle as it goes in. I was told this was more sanitary than wiping the needle with an alcohol swab.
I found wiping the needle stings really bad as it breaks the skin.
Personally I don't notice a thing.
I've only mixed ghrp2 and mod grf in the same syringe. Seems to work fine, as it feels the same most of the time, I even have them mixed for up to a week at times.
I would be super careful with that. I don't think that is anything for a novice to do. After you feel comfortable with one type of peptide maybe you could combine them for better effect. It might be something that would work for you. Good luck to you, just make sure you follow the dosage instructions. It is one of the things you need to do.
That's not true. It is always recommended to combine your ghrp with ghrh because of the synergy.
I haven't noticed this. Does this normally happen?
For me, yes. I don't know, maybe I have some allergice reaction to alcohol.
Reply With Quote